SEMI AUTOMATIC SINGLE HEAD WEIGH FILLER

Model Number UT - 72

• The product feeding system consists of a set of vibratory trays ( front & rear) feeds the product into
• the pan. A uniform layer is maintained by synchroniz ing the feeding from the rear and front vibrators to enable accurate weighing.
• The receiving pan is mounted at a strain gauge called load cell, which provides a signal the signal though small, is amplified and transmitted to process control electronics.
• In the process control the control panel receives the signal from the load cell and after processing the
• same, compares the data with the pre-set values and gives signal to the vibrators.
• The control panel has two set values – Bulk weight value and Target set weight value. The bulk weight
• is always set less than the target value, which is normally 8 0 to 95% depending upon the product characteristics. Initially both the vibrators run in Coarse mode and when the bulk weight is achieved the vibrators enter the fine mode and the coarse trap shutter closes and stops the coarse feeding.
• The final set weight is achieved by fine feeding through fine tray to achieve accurate weighing.
• On achieving the preset weight the pan opens and dumps the product.